Double Wooden Front Doors With Glass - When it comes to keeping your house in tip-top shape, nothing could be more annoying than a sliding glass door that won't slip. After all, what is the purpose of owning a gorgeous glass door that leads into a scenic backyard if the darn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass door angst, I chose to write this article to notify you of the number 1 reason why your sliding glass door won't slip - and what you can do about it! The number 1 reason why your sliding glass door won't side is that a lot of dirt and debris have clogged up the wheels and the course of your door panel. This isn't a hard fix, but since nearly all sliding glass doors are rather heavy, it's wise if you have another individual present to help you.
The first step would be to examine how your sliding glass door is fixed into the track. The vast majority of sliding glass doors have a strip that runs along the surface of the framework that holds the doorways in vertical alignment, positioning the wheels to fit neatly within the sliding track. To start, let us use a very simple screwdriver to remove that strip on top. Once the strip is removed, gradually tilt the door out of the frame, then remove it out of the frame altogether. Turn the door on its side and also examine the wheels at the bottom of the door. Remember, some sliding glass doors could be upwards of 90 pounds, so either acquire some help or be quite confident in your physical skill.
Most commonly, you'll discover the wheels are full of soot and debris, and the track is also probably quite dirty. To wash the wheels, use compressed air and needle tip pliers. Be careful to pull every single hair out of the wheel bearings. It's prudent to be diligent in this measure, so you don't need to make a custom of the procedure. Once the wheels are completely clean, spray a tiny bit of peppermint oil into the wheel bearings, spinning the wheel as you apply the oil. (The ideal option for your petroleum is DuPont's Teflon non invasive dry film lubricant.) It's equally important to clean the track that the wheels rest on.
Use moist paper towels to remove the grit and soil, and then spray on the penetrating oil along the track so it's well-applied. Use a clean paper towel to make sure it's evenly applied. This is the point where the sliding door matches with another surface of the door frame. A general guideline is to just wipe down anything that seems dirty. Remember, even when dirt isn't necessarily on the track itself, it may finally fall into the track causing your door to require down another wipe. If you notice any breeding advantages that feel sticky, take a paper towel and spray some oil onto it, then wipe the oil on the sticky surfaces. When you've done all this, reinstall the door. You should notice right away that the door is much easier to slip, and should require significantly less effort.
If for any reason that the door is still tough to roll, it's likely one of the following reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the track and is consequently hitting on the top plate of the door frame. |} If your wheels are burnt out, sadly, you are going to need to call the manufacture of your sliding glass door and request new wheels. If on the other hand, your door is hitting on the top plate of your door frame, you can correct it by locating the screw holes at the very bottom of your sliding glass door. On most sliding glass doors, there are two screws which could be turned with either a flathead screwdriver or an alan wrench. Turn to the right to raise the door, or switch to the left to lower the door.