Half Glass Dutch Door - When it comes to keeping your home in tip-top shape, nothing could be frustrating than a sliding glass door which will not slide. After all, what is the purpose of owning a beautiful glass door which leads into a picturesque backyard if the damn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass door angst, I chose to write this article to notify you of the number 1 reason why your sliding glass door will not slide - and everything you can do about it! The number 1 reason why your sliding glass door will not side is that a lot of debris and dirt have clogged up the wheels and the track of your door panel. This isn't a difficult fix, but because most sliding glass doors are rather heavy, it's best if you have another individual present to aid you.
Step one is to examine how your sliding glass door is repaired into the track. The vast majority of sliding glass doors have a strip which runs along the surface of the framework that holds the doorways in vertical alignment, placing the wheels to fit neatly within the sliding path. To begin, let's use a simple screwdriver to remove that strip on very top. Once the strip is removed, gradually tilt the door out of this frame, then remove it out of the frame altogether. Turn the door on its side and examine the wheels in the bottom of the door. Bear in mind, some sliding glass doors could be upwards of 90 pounds, so either acquire some aid or be quite confident in your physical skill.
Once the door is on its side, you can carefully inspect the wheels and the track. Most commonly, you'll discover the wheels are full of soot and debris, and the track is also likely quite filthy. To clean the brakes, then use compressed air and needle tip pliers. Be careful to pull every last hair out of the wheel bearings. It is wise to be diligent at this measure, so you don't need to make a habit of this process. Once the wheels are totally clean, spray a tiny bit of peppermint oil to the wheel bearings, spinning the wheel as you use the oil. (The ideal option for your oil is DuPont's Teflon non invasive dry film lubricant.) It is equally important to clean out the track that the wheels rest on.
Use damp paper towels to remove the grit and soil, and then spray on the penetrating oil along the track so it's well-applied. Use a clean paper towel to ensure it's evenly applied. While you're at it, clean up all the "mating-edges" of this door. This is the point where the sliding door meets with any other surface of the door frame. A general guideline is to simply wipe down anything which looks filthy. Bear in mind, even when dirt isn't necessarily on the track itself, it can eventually fall into the track causing your door to need down another wipe. If you notice any breeding advantages that feel sticky, take a paper towel and then spray some oil onto it, then wipe out the oil on the sticky surfaces. When you've done all this, reinstall the door. You should note right away that the door is much easier to slide, and should require significantly less effort.
If for any reason that the door remains difficult to roll, it's probable one of these reasons: either your wheels are burnt out, or your sliding glass door is sitting too high on the track and is consequently hitting on the upper plate of the door frame. |} If your wheels are burnt out, unfortunately, you'll need to call the production of your sliding glass door and request new wheels. Switch to the right to raise the door, or turn to the left to lessen the door.