Patterned Glass For Interior Doors - When it comes to maintaining your house in tip-top shape, nothing can be more annoying than a sliding glass door which won't slip. After all, what is the purpose of owning a beautiful glass door which leads out to a picturesque backyard if the damn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I chose to write this article to notify you of the number 1 reason why your sliding glass door won't slip - and what you can do about it! The number 1 reason why your sliding glass door won't side is that a lot of debris and dirt have clogged up the wheels and the track of your door panel. This is not a hard fix, but because most sliding glass doors are quite heavy, it is wise if you have another individual present to aid you.
The first step is to analyze how your sliding glass door is repaired into the monitor. The vast majority of sliding glass doors have a strip which runs along the surface of the frame that holds the doors in vertical alignment, placing the wheels to fit neatly within the sliding track. To begin, let us use a very simple screwdriver to remove that strip on top. Once the strip is removed, slowly tilt the door out of the frame, then remove it out of the frame completely. Turn the doorway on its side and also analyze the wheels at the base of the door. Remember, some sliding glass doors can be upwards of 90 pounds, so either get some aid or be quite confident on your physical ability.
Most commonly, you will discover the wheels are full of soot and debris, and the track is also likely quite dirty. To clean the wheels, use compressed air and needle tip pliers. Be careful to pull every last hair out of the wheel bearings. It is wise to be diligent in this measure, so you don't need to make a custom of this process. Once the wheels are totally sterile, spray a tiny bit of peppermint oil to the wheel bearings, spinning the wheel as you use the oil. (The best option for your petroleum is DuPont's Teflon non-stick dry film lubricant.) It is just as important to clean out the track that the brakes rest on.
Use moist paper towels to remove the grit and dirt, and then spray the penetrating oil along the track so it is well-applied. Use a clean paper towel to ensure it is evenly applied. While you're at it, clean up all of the "mating-edges" of the doorway. This is the point where the sliding door matches with another surface of the door frame. A general rule of thumb is to just wipe down anything which looks dirty. Remember, even if the dirt is not necessarily on the track itself, it can eventually fall into the track causing your doorway to need down another wipe. If you notice any breeding advantages that feel tacky, take a paper towel and spray some oil on it, then wipe out the oil onto the tacky surfaces. When you've done all this, reinstall the doorway. You should notice immediately that the doorway is much easier to slip, and should require significantly less effort.
When for any reason that the door remains tough to rollup, it is likely one of these reasons: either your brakes are completely burned out, or your sliding glass door is sitting too high on the track and is thus hitting the top plate of the door frame. |} If your brakes are burnt out, sadly, you'll need to call the production of your sliding glass door and ask new wheels. On most sliding glass doors, there are two screws that can be turned using either a flathead screwdriver or an alan wrench. Switch to the right to raise the doorway, or turn to the left to lower the door.