Large Sliding Glass Doors With Screens - When it comes to maintaining your house in tip-top shape, nothing could be frustrating than a sliding glass door which won't slide. After all, what is the purpose of having a beautiful glass door which leads into a scenic backyard if the darn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass doorway angst, I decided to write this article to inform you of the number 1 reason why your sliding glass door won't slide - and what you can do about it! The number 1 reason why your sliding glass door won't side is that a lot of debris and dirt have clogged up the wheels and the course of your door panel. This is not a hard fix, but since nearly all sliding glass doors are rather heavy, it is wise if you have another individual present to help you.
The first step is to examine how your sliding glass door is fixed into the monitor. The majority of sliding glass doors have a strip which runs along the top of the frame that holds the doors in vertical alignment, positioning the wheels to fit neatly within the sliding path. To start, let us use a very simple screwdriver to remove that strip at the top. Once the strip is removed, slowly tilt the door out of this frame, then remove it out of the frame altogether. Turn the doorway on its side and examine the wheels in the base of the door. Bear in mind, some sliding glass doors could be upwards of 90 lbs, so either acquire some help or be quite confident in your physical ability.
Once the door is on its side, it's possible to carefully examine the wheels and the monitor. Most commonly, you'll discover the wheels are full of soot and debris, and the track is also likely quite dirty. To wash the wheels, use compressed air and needle tip pliers. Take care to pull every single hair out of the wheel bearings. It is wise to be diligent in this measure, so you don't have to make a habit of this process. Once the wheels are completely clean, spray a little bit of peppermint oil into the wheel bearings, turning the wheel as you use the oil. (The ideal option for the petroleum is DuPont's Teflon non-stick dry film lubricant.) It is equally important to clean out the track that the wheels rest on.
Use moist paper towels to remove the grit and soil, and then spray the penetrating oil along the trail so it is well-applied. While you're at it, clean up all of the "mating-edges" of this doorway. This is where the sliding door matches with any other surface of the door frame. A general rule of thumb is to just wipe down anything which seems dirty. Bear in mind, even when dirt is not necessarily on the trail itself, it may finally collapse into the trail causing your doorway to need another wipe down. If you become aware of any breeding advantages that feel sticky, take a paper towel and then spray some oil onto it, then wipe out the oil on the sticky surfaces. After you've done all this, reinstall the doorway. You should note right away that the doorway is a lot easier to slide, and should require significantly less effort.
When for any reason the door remains tough to roll, it is likely one of the following reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the trail and is thus hitting the top plate of the door frame. |} If your wheels are burned out, unfortunately, you are going to have to call the production of your sliding glass door and ask new wheels. On most sliding glass doors, there are two screws which could be turned with either a flathead screwdriver or an alan wrench. Switch to the right to raise the doorway, or turn to the left to lower the door.