Oak Media Cabinet With Glass Doors - If it comes to maintaining your home in tip-top shape, nothing could be more annoying than a sliding glass door that won't slip. After all, what is the purpose of owning a gorgeous glass door that leads out to a picturesque backyard if the damn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I chose to write this report to notify you of the number 1 reason why your sliding glass door won't slip - and what you can do about it! The number 1 reason why your sliding glass door won't drawback is that a lot of debris and dirt have clogged up the wheels and the track of your door panel. This is not a difficult fix, but since nearly all sliding glass doors are rather heavy, it's best if you have another person present to help you.
The first step would be to analyze how your sliding glass door is repaired into the track. The majority of sliding glass doors have a strip that runs along the surface of the frame that holds the doors in vertical orientation, positioning the wheels to fit neatly over the sliding path. To begin, let's use a very simple screwdriver to remove that strip at the top. When the strip is removed, slowly tilt the door out of the frame, then remove it out of the frame completely. Turn the doorway on its side and analyze the wheels at the bottom of the door. Bear in mind, some sliding glass doors could be upwards of 90 lbs, so either get some help or become very confident in your physical ability.
Most commonly, you'll discover the wheels are full of soot and debris, and the track can also be likely very filthy. To clean the wheels, use compressed air and needle tip pliers. Be careful to pull every last hair out of the wheel bearings. It's wise to be diligent in this measure, so you don't have to make a custom of the procedure. When the wheels are totally clean, spray a little bit of peppermint oil to the wheel bearings, turning the wheel as you apply the oil. (The ideal choice for your petroleum is DuPont's Teflon non-stick dry film lubricant.) It's just as important to clean the track that the wheels rest on.
Use moist paper towels to remove the grit and dirt, and then spray the penetrating oil along the trail so it's well-applied. This is where the sliding door meets with any other surface of the door frame. A general guideline is to just wipe down anything that seems filthy. Bear in mind, even if the dirt is not necessarily on the trail itself, it may eventually collapse into the trail causing your doorway to require another wipe down. If you become aware of any mating edges that feel tacky, take a paper towel and spray some oil on it, then wipe the oil onto the tacky surfaces. When you have done all this, reinstall the doorway. You should notice immediately that the doorway is much simpler to slip, and should require significantly less effort.
When for any reason that the door is still difficult to roll, it's likely one of the following reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the trail and is thus hitting the top plate of the door frame. |} If your wheels are burned out, sadly, you'll have to call the production of your sliding glass door and request new wheels. Turn to the right to raise the doorway, or switch to the left to lower the door.