Sliding Glass Door Panels - When it comes to keeping your house in tiptop shape, nothing could be more annoying than a sliding glass door which will not slip. After all, what is the purpose of owning a gorgeous glass door which leads out to a picturesque backyard if the darn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I chose to write this article to inform you of the number 1 reason why your sliding glass door will not slip - and what you can do about it! The number 1 reason why your sliding glass door will not drawback is that too much dirt and debris have clogged up the wheels and the track of your door panel. This is not a hard fix, but since nearly all sliding glass doors are rather heavy, it is best if you've got another person present to aid you.
Step one would be to analyze how your sliding glass door is repaired to the track. The vast majority of sliding glass doors have a strip which runs along the top of the framework that holds the doorways in vertical orientation, positioning the wheels to fit neatly over the sliding track. To start, let's use a very simple screwdriver to remove that strip on top. When the strip is removed, gradually tilt the door out of the frame, then eliminate it out of the frame completely. Turn the doorway on its side and also analyze the wheels in the base of the door. Remember, some sliding glass doors could be upwards of 90 lbs, so either acquire some aid or become quite confident in your physical ability.
When the door is on its side, it's possible to carefully examine the wheels and the track. Most commonly, you'll find the wheels are full of soot and debris, and the track is also likely quite dirty. To wash the wheels, use compressed air and needle tip pliers. Be careful to pull every last hair out of the wheel bearings. It is prudent to be diligent in this step, so you don't have to make a habit of the procedure. When the wheels are completely clean, spray a tiny bit of peppermint oil to the wheel bearings, spinning the wheel as you use the oil. (The best choice for the petroleum is DuPont's Teflon non invasive dry film lubricant.) It is just as important to clean out the track that the brakes rest on.
Use moist paper towels to remove the grit and soil, and then spray on the penetrating oil along the track so it is well-applied. Use a clean paper towel to make sure it is evenly applied. While you're at it, clean up all the "mating-edges" of the doorway. This is where the sliding door meets with another surface of the door frame. A general guideline is to simply wipe down anything which seems dirty. Remember, even if the dirt is not always on the track itself, it may finally collapse to the track causing your doorway to need down another wipe. If you become aware of any mating edges that feel tacky, take a paper towel and then spray some oil onto it, then wipe out the oil on the tacky surfaces. When you have done all this, reinstall the doorway. You should note right away that the doorway is a lot simpler to slip, and should require significantly less effort.
When for any reason the door remains difficult to rollup, it is likely one of the following reasons: either your brakes are completely burned out, or your sliding glass door is sitting too high on the track and is consequently hitting on the top plate of the door frame. |} If your brakes are burnt out, sadly, you'll have to call the production of your sliding glass door and ask new wheels. Turn to the right to lift the doorway, or turn to the left to lower the door.