Tv Media Stand With Sliding Glass Doors - When it comes to keeping your home in tip-top shape, nothing could be frustrating than a sliding glass door that won't slide. After all, what is the purpose of owning a gorgeous glass door that leads into a scenic backyard if the damn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass door angst, I decided to write this report to inform you of the number 1 reason why your sliding glass door won't slide - and what you can do about it! The number 1 reason why your sliding glass door won't side is that a lot of debris and dirt have clogged the wheels up and the course of your door panel. This is not a hard fix, but because nearly all sliding glass doors are rather heavy, it is best if you have another individual present to help you.
The first step would be to analyze how your sliding glass door is fixed into the track. The vast majority of sliding glass doors have a strip that runs across the top of the framework that holds the doorways in vertical alignment, placing the wheels to fit neatly over the sliding track. To start, let us use a simple screwdriver to remove that strip on very top. When the strip is removed, gradually tilt the door from the frame, then eliminate it from the frame completely. Turn the door on its side and analyze the wheels in the bottom of the door. Bear in mind, some sliding glass doors could be upwards of 90 pounds, so either acquire some help or become very confident in your physical skill.
Most commonly, you'll find the wheels are filled with soot and debris, and the track is also likely very dirty. To clean the brakes, then use compressed air and needle tip pliers. Take care to pull every single hair from the wheel bearings. It is prudent to be diligent at this step, so you don't need to make a habit of this procedure. When the wheels are completely sterile, spray a tiny bit of peppermint oil to the wheel bearings, spinning the wheel as you use the oil. (The ideal option for the oil is DuPont's Teflon non-stick dry film lubricant.) It is equally important to clean out the track that the wheels rest on.
Use damp paper towels to remove the grit and dirt, and then spray on the penetrating oil across the trail so it is well-applied. While you're at it, clean up all the "mating-edges" of the door. This is where the sliding door matches with another surface of the door frame. A general guideline is to just wipe down anything that looks dirty. Bear in mind, even if the dirt is not necessarily on the trail itself, it can finally collapse into the trail causing your door to need another wipe down. If you notice any breeding advantages that feel sticky, have a paper towel and then spray some oil on it, then wipe out the oil onto the sticky surfaces. After you've done all this, reinstall the door. You should note right away that the door is much simpler to slide, and should require significantly less effort.
When for any reason the door is still tough to roll, it is probable one of these reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the trail and is thus hitting on the top plate of the door frame. |} If your wheels are burned out, unfortunately, you are going to need to call the production of your sliding glass door and request new wheels. On most sliding glass doors, there are two screws that could be turned with either a flathead screwdriver or an alan wrench. Turn to the right to lift the door, or turn to the left to lower the door.