Pella Sliding Glass Door Standard Sizes - When it comes to keeping your home in tiptop shape, nothing can be more annoying than a sliding glass door that will not slip. After all, what is the purpose of owning a gorgeous glass door that leads out to a scenic backyard if the darn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I decided to write this report to inform you of the number 1 reason why your sliding glass door will not slip - and everything you can do about it! The number 1 reason why your sliding glass door will not side is that too much debris and dirt have clogged the wheels up and the track of your door panel. This is not a difficult fix, but because nearly all sliding glass doors are rather heavy, it is wise if you have another person present to aid you.
The first step would be to examine how your sliding glass door is fixed to the monitor. The vast majority of sliding glass doors have a strip that runs along the top of the frame that holds the doorways in vertical alignment, placing the wheels to fit neatly over the sliding track. To begin, let us use a simple screwdriver to remove that strip at the top. Once the strip is removed, gradually tilt the door from this frame, then remove it from the frame altogether. Turn the doorway on its side and examine the wheels at the base of the door. Remember, some sliding glass doors can be upwards of 90 pounds, so either get some aid or become very confident on your physical ability.
Once the door is on its side, you can carefully inspect the wheels and the monitor. Most commonly, you will find the wheels are full of soot and debris, and the track can also be probably very dirty. To clean the wheels, use compressed air and needle tip pliers. Take care to pull every single hair from the wheel bearings. It is wise to be diligent in this measure, so you don't have to make a habit of this procedure. Once the wheels are totally sterile, spray a tiny bit of peppermint oil to the wheel bearings, turning the wheel as you use the oil. (The ideal choice for your oil is DuPont's Teflon non invasive dry film lubricant.) It is equally important to clean the track that the brakes rest on.
Use damp paper towels to remove the grit and dirt, and then spray the penetrating oil along the trail so it is well-applied. Use a clean paper towel to make sure it is evenly applied. While you're at it, clean up all of the "mating-edges" of this doorway. This is the point where the sliding door meets with another surface of the door frame. A general rule of thumb is to simply wipe down anything that seems dirty. Remember, even when dirt is not always on the trail itself, it may eventually collapse to the trail causing your doorway to require down another wipe. If you become aware of any mating edges that feel tacky, have a paper towel and then spray some oil onto it, then wipe the oil onto the tacky surfaces. When you've done all this, reinstall the doorway. You should notice right away that the doorway is a lot simpler to slip, and should require significantly less effort.
If for any reason the door is still tough to rollup, it is probable one of the following reasons: either your brakes are completely burned out, or your sliding glass door is sitting too high on the trail and is thus hitting the top plate of the door frame. |} If your brakes are burned out, sadly, you'll have to call the production of your sliding glass door and request new wheels. If on the other hand, your doorway is hitting the top plate of your door frame, you can correct it by finding the screw holes at the very base of your sliding glass door. Turn to the right to lift the doorway, or switch to the left to lessen the door.