Acid Etched Glass Shower Doors - When it comes to maintaining your home in tip-top shape, nothing could be more annoying than a sliding glass door that will not slip. After all, what's the purpose of having a gorgeous glass door that leads into a scenic backyard if the damn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass door angst, I chose to write this report to notify you of the number 1 reason why your sliding glass door will not slip - and what you can do about it! The number 1 reason why your sliding glass door will not side is that a lot of debris and dirt have clogged the wheels up and the track of your door panel. This is not a hard fix, but since most sliding glass doors are rather heavy, it is best if you've got another individual present to help you.
The first step would be to analyze how your sliding glass door is repaired into the monitor. The majority of sliding glass doors have a strip that runs across the top of the framework that holds the doors in vertical alignment, placing the wheels to fit neatly over the sliding track. To start, let's use a very simple screwdriver to remove that strip on top. Once the strip is removed, gradually tilt the door out of this frame, then eliminate it out of the frame altogether. Turn the door on its side and analyze the wheels at the base of the door. Bear in mind, some sliding glass doors could be upwards of 90 lbs, so either acquire some help or become very confident in your physical ability.
Once the door is on its side, you can closely examine the wheels and the monitor. Most commonly, you will discover the wheels are filled with soot and debris, and the track can also be probably very dirty. To wash the brakes, then use compressed air and needle tip pliers. Take care to pull every last hair out of the wheel bearings. It's prudent to be diligent in this step, so you don't need to make a habit of this procedure. Once the wheels are completely clean, spray a little bit of peppermint oil into the wheel bearings, spinning the wheel as you apply the oil. (The ideal choice for the oil is DuPont's Teflon non invasive dry film lubricant.) It's just as important to clean the track that the wheels rest on.
Use moist paper towels to remove the grit and dirt, and then spray on the penetrating oil across the trail so it is well-applied. While you're at it, clean up all of the "mating-edges" of this door. This is where the sliding door meets with another surface of the door frame. A general guideline is to just wipe down anything that looks dirty. Bear in mind, even when dirt is not necessarily on the trail itself, it can eventually collapse into the trail causing your door to require down another wipe. If you become aware of any breeding advantages that feel sticky, take a paper towel and then spray some oil onto it, then wipe the oil on the sticky surfaces. When you've done all this, reinstall the door. You should notice right away that the door is much simpler to slip, and should require significantly less effort.
If for any reason the door is still tough to rollup, it is probable one of the following reasons: either your wheels are burnt out, or your sliding glass door is sitting too high on the trail and is thus hitting on the top plate of the door frame. |} If your wheels are burnt out, unfortunately, you'll need to call the manufacture of your sliding glass door and request new wheels. If on the other hand, your door is hitting on the top plate of your door frame, you can adjust this by finding the screw holes at the very base of your sliding glass door. On most sliding glass doors, there are two screws which could be turned using either a flathead screwdriver or an alan wrench. Turn to the right to lift the door, or switch to the left to lower the door.