10' Wide Sliding Glass Doors - When it comes to keeping your house in tiptop shape, nothing can be more annoying than a sliding glass door that will not slip. After all, what's the purpose of having a beautiful glass door that leads into a picturesque backyard if the damn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I chose to write this article to inform you of the number 1 reason why your sliding glass door will not slip - and everything you can do about it! The number 1 reason why your sliding glass door will not drawback is that too much dirt and debris have clogged up the wheels and the course of your door panel. This isn't a difficult fix, but because nearly all sliding glass doors are rather heavy, it's best if you've got another individual present to aid you.
Step one would be to examine how your sliding glass door is repaired into the track. The vast majority of sliding glass doors have a strip that runs along the top of the frame that holds the doorways in vertical orientation, placing the wheels to fit neatly over the sliding path. To start, let's use a simple screwdriver to remove that strip on top. When the strip is removed, gradually tilt the door out of this frame, then remove it out of the frame altogether. Turn the doorway on its side and also examine the wheels in the bottom of the door. Remember, some sliding glass doors can be upwards of 90 pounds, so either acquire some aid or be very confident on your physical ability.
Most commonly, you'll find the wheels are full of soot and debris, and the track is also likely very dirty. To wash the wheels, use compressed air and needle tip pliers. Take care to pull every single hair out of the wheel bearings. It's wise to be diligent in this step, so you don't have to make a custom of this procedure. When the wheels are totally clean, spray a little bit of penetrating oil into the wheel bearings, turning the wheel as you use the oil. (The best option for the oil is DuPont's Teflon non invasive dry film lubricant.) It's equally important to clean out the track that the brakes rest on.
Use damp paper towels to remove the grit and dirt, and then spray the penetrating oil along the trail so it's well-applied. Use a clean paper towel to ensure it's evenly applied. While you're at it, clean up all the "mating-edges" of this doorway. This is where the sliding door matches with another surface of the door frame. A general rule of thumb is to simply wipe down anything that seems dirty. Remember, even when dirt isn't necessarily on the trail itself, it can finally collapse into the trail causing your doorway to require another wipe down. If you notice any breeding advantages that feel sticky, have a paper towel and spray some oil onto it, then wipe out the oil onto the sticky surfaces. After you have done all this, reinstall the doorway. You should notice immediately that the doorway is much easier to slip, and should require significantly less effort.
If for any reason the door remains tough to roll, it's probable one of these reasons: either your brakes are burnt out, or your sliding glass door is sitting too high on the trail and is thus hitting the top plate of the door frame. |} If your brakes are burned out, sadly, you'll have to call the production of your sliding glass door and ask new wheels. If on the other hand, your doorway is hitting the top plate of your door frame, you can correct it by locating the screw holes in the very bottom of your sliding glass door. Turn to the right to raise the doorway, or switch to the left to lower the door.