Purple Amethyst Glass Door Knob - When it comes to maintaining your house in tip-top shape, nothing could be more annoying than a sliding glass door that won't slip. After all, what's the purpose of having a beautiful glass door that leads into a scenic backyard if the darn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I decided to write this report to notify you of the number 1 reason why your sliding glass door won't slip - and what you can do about it! The number 1 reason why your sliding glass door won't side is that too much debris and dirt have clogged the wheels up and the course of your door panel. This isn't a hard fix, but because nearly all sliding glass doors are quite heavy, it's best if you have another individual present to aid you.
The first step is to analyze how your sliding glass door is repaired to the track. The vast majority of sliding glass doors have a strip that runs across the surface of the framework that holds the doorways in vertical orientation, placing the wheels to fit neatly within the sliding track. To begin, let us use a simple screwdriver to remove that strip at the very top. Once the strip is removed, gradually tilt the door from this frame, then eliminate it from the frame altogether. Turn the doorway on its side and analyze the wheels at the base of the door. Remember, some sliding glass doors could be upwards of 90 lbs, so either get some aid or become quite confident on your physical ability.
Most commonly, you will discover the wheels are full of soot and debris, and the track can also be likely quite dirty. To clean the wheels, use compressed air and needle tip pliers. Take care to pull every last hair from the wheel bearings. It's prudent to be diligent in this measure, so you don't have to make a habit of the procedure. Once the wheels are completely clean, spray a little bit of penetrating oil into the wheel bearings, turning the wheel as you use the oil. (The ideal choice for your oil is DuPont's Teflon non invasive dry film lubricant.) It's equally important to clean the track that the wheels rest on.
Use damp paper towels to remove the grit and dirt, and then spray on the penetrating oil across the trail so it's well-applied. While you're at it, clean up all of the "mating-edges" of this doorway. This is the point where the sliding door meets with any other surface of the door frame. A general rule of thumb is to just wipe down anything that seems dirty. Remember, even if the dirt isn't always on the trail itself, it can eventually collapse to the trail causing your doorway to require down another wipe. If you become aware of any mating edges that feel tacky, have a paper towel and then spray some oil on it, then wipe the oil onto the tacky surfaces. After you have done all this, reinstall the doorway. You should note immediately that the doorway is a lot simpler to slip, and should require significantly less effort.
If for any reason the door remains difficult to rollup, it's likely one of the following reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the trail and is consequently hitting on the top plate of the door frame. |} If your wheels are burnt out, sadly, you are going to have to call the production of your sliding glass door and request new wheels. On most sliding glass doors, there are two screws that could be turned using either a flathead screwdriver or an alan wrench. Switch to the right to raise the doorway, or turn to the left to lower the door.