Sliding Fabric Panels For Sliding Glass Doors - When it comes to keeping your home in tiptop shape, nothing can be frustrating than a sliding glass door that won't slide. After all, what is the purpose of having a gorgeous glass door that leads out to a picturesque backyard if the darn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass door angst, I chose to write this article to inform you of the number 1 reason why your sliding glass door won't slide - and what you can do about it! The number 1 reason why your sliding glass door won't side is that a lot of debris and dirt have clogged up the wheels and the course of your door panel. This is not a difficult fix, but because most sliding glass doors are quite heavy, it's best if you have another person present to help you.
Step one is to examine how your sliding glass door is repaired to the track. The majority of sliding glass doors have a strip that runs along the top of the frame that holds the doorways in vertical alignment, positioning the wheels to fit neatly within the sliding path. To begin, let us use a simple screwdriver to remove that strip at the top. Once the strip is removed, slowly tilt the door from the frame, then eliminate it from the frame altogether. Turn the door on its side and examine the wheels in the bottom of the door. Remember, some sliding glass doors can be upwards of 90 lbs, so either acquire some help or become very confident on your physical skill.
Most commonly, you will find the wheels are full of soot and debris, and the track is also likely very filthy. To wash the wheels, use compressed air and needle tip pliers. Be careful to pull every single hair from the wheel bearings. It's wise to be diligent in this measure, so you don't have to make a custom of the procedure. Once the wheels are totally clean, spray a tiny bit of peppermint oil into the wheel bearings, turning the wheel as you use the oil. (The best choice for the oil is DuPont's Teflon non-stick dry film lubricant.) It's just as important to clean the track that the brakes rest on.
Use moist paper towels to remove the grit and soil, and then spray on the penetrating oil along the track so it's well-applied. While you're at it, clean up all the "mating-edges" of the door. This is where the sliding door matches with another surface of the door frame. A general rule of thumb is to simply wipe down anything that seems filthy. Remember, even when dirt is not always on the track itself, it can finally collapse to the track causing your door to require down another wipe. If you notice any mating edges that feel sticky, take a paper towel and spray some oil on it, then wipe the oil on the sticky surfaces. After you have done all this, reinstall the door. You should notice right away that the door is much simpler to slide, and should require significantly less effort.
If for any reason that the door remains tough to roll, it's likely one of the following reasons: either your brakes are completely burned out, or your sliding glass door is sitting too high on the track and is thus hitting on the upper plate of the door frame. |} If your brakes are burnt out, unfortunately, you'll have to call the manufacture of your sliding glass door and ask new wheels. Turn to the right to raise the door, or turn to the left to lessen the door.