Sliding Closet Doors Frosted Glass - If it comes to keeping your house in tiptop shape, nothing could be more annoying than a sliding glass door which will not slide. After all, what's the purpose of having a beautiful glass door which leads into a picturesque backyard if the damn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass doorway angst, I decided to write this article to inform you of the number 1 reason why your sliding glass door will not slide - and what you can do about it! The number 1 reason why your sliding glass door will not drawback is that a lot of debris and dirt have clogged up the wheels and the track of your door panel. This is not a hard fix, but because nearly all sliding glass doors are rather heavy, it is best if you have another person present to help you.
Step one is to analyze how your sliding glass door is repaired into the monitor. The vast majority of sliding glass doors have a strip which runs along the top of the frame that holds the doorways in vertical alignment, positioning the wheels to fit neatly over the sliding path. To begin, let us use a simple screwdriver to remove that strip at the top. Once the strip is removed, gradually tilt the door from this frame, then remove it from the frame altogether. Turn the doorway on its side and also analyze the wheels in the base of the door. Bear in mind, some sliding glass doors could be upwards of 90 lbs, so either acquire some help or be very confident in your physical ability.
Once the door is on its side, it's possible to closely examine the wheels and the monitor. Most commonly, you will find the wheels are filled with soot and debris, and the track can also be likely very dirty. To clean the wheels, use compressed air and needle tip pliers. Take care to pull every last hair from the wheel bearings. It is wise to be diligent at this measure, so you don't need to make a habit of this procedure. Once the wheels are totally sterile, spray a little bit of penetrating oil into the wheel bearings, turning the wheel as you apply the oil. (The ideal option for the petroleum is DuPont's Teflon non-stick dry film lubricant.) It is equally important to clean out the track that the wheels rest on.
Use damp paper towels to remove the grit and dirt, and then spray the penetrating oil along the track so it is well-applied. Use a clean paper towel to make sure it is evenly applied. This is the point where the sliding door meets with another surface of the door frame. A general guideline is to simply wipe down anything which looks dirty. Bear in mind, even when dirt is not always on the track itself, it may finally fall into the track causing your doorway to require another wipe down. If you become aware of any mating edges that feel tacky, have a paper towel and then spray some oil onto it, then wipe out the oil onto the tacky surfaces. After you have done all this, reinstall the doorway. You should notice right away that the doorway is much easier to slide, and should require significantly less effort.
When for any reason that the door remains tough to roll, it is likely one of the following reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the track and is consequently hitting the top plate of the door frame. |} If your wheels are burned out, sadly, you are going to need to call the manufacture of your sliding glass door and ask new wheels. On most sliding glass doors, you can find two screws which could be turned using either a flathead screwdriver or an alan wrench. Switch to the right to lift the doorway, or turn to the left to lower the door.
Tags: #asian series sliding closet door with frosted glass insert #frosted glass sliding doors for closet #sliding closet doors frosted glass #sliding closet doors opaque glass #sliding closet doors with frosted glass