Interior Wood Door With Glass Panels - When it comes to keeping your house in tiptop shape, nothing can be frustrating than a sliding glass door which won't slip. After all, what is the purpose of owning a gorgeous glass door which leads into a scenic backyard if the damn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I chose to write this report to notify you of the number 1 reason why your sliding glass door won't slip - and what you can do about it! The number 1 reason why your sliding glass door won't drawback is that a lot of dirt and debris have clogged the wheels up and the course of your door panel. This isn't a difficult fix, but because most sliding glass doors are quite heavy, it is best if you've got another person present to help you.
The first step is to examine how your sliding glass door is fixed into the monitor. The vast majority of sliding glass doors have a strip which runs across the surface of the frame that holds the doors in vertical alignment, positioning the wheels to fit neatly over the sliding track. To begin, let's use a simple screwdriver to remove that strip at the very top. Once the strip is removed, gradually tilt the door from the frame, then eliminate it from the frame completely. Turn the doorway on its side and examine the wheels at the base of the door. Bear in mind, some sliding glass doors can be upwards of 90 lbs, so either get some help or be quite confident on your physical ability.
Once the door is on its side, it's possible to carefully inspect the wheels and the monitor. Most commonly, you'll find the wheels are filled with soot and debris, and the track is also probably quite dirty. To clean the wheels, use compressed air and needle tip pliers. Be careful to pull every last hair from the wheel bearings. It is wise to be diligent in this measure, so you don't need to make a habit of the process. Once the wheels are completely clean, spray a little bit of penetrating oil into the wheel bearings, spinning the wheel as you use the oil. (The ideal choice for your oil is DuPont's Teflon non-stick dry film lubricant.) It is equally important to clean the track that the brakes rest on.
Use damp paper towels to remove the grit and dirt, and then spray on the penetrating oil across the track so it is well-applied. While you're at it, clean up all the "mating-edges" of the doorway. This is the point where the sliding door matches with any other surface of the door frame. A general guideline is to simply wipe down anything which looks dirty. Bear in mind, even when dirt isn't necessarily on the track itself, it may finally fall into the track causing your doorway to require down another wipe. If you become aware of any breeding advantages that feel tacky, take a paper towel and then spray some oil on it, then wipe the oil onto the tacky surfaces. When you have done all this, reinstall the doorway. You should notice immediately that the doorway is a lot simpler to slip, and should require significantly less effort.
When for any reason the door remains difficult to roll, it is likely one of these reasons: either your brakes are burnt out, or your sliding glass door is sitting too high on the track and is thus hitting on the top plate of the door frame. |} If your brakes are burned out, sadly, you are going to need to call the manufacture of your sliding glass door and ask new wheels. Switch to the right to raise the doorway, or switch to the left to lower the door.