Secure Glass Cabinet Door - When it comes to keeping your home in tiptop shape, nothing could be more annoying than a sliding glass door which will not slip. After all, what's the purpose of having a gorgeous glass door which leads out to a picturesque backyard if the darn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I chose to write this article to notify you of the number 1 reason why your sliding glass door will not slip - and everything you can do about it! The number 1 reason why your sliding glass door will not drawback is that too much dirt and debris have clogged up the wheels and the track of your door panel. This is not a difficult fix, but since most sliding glass doors are quite heavy, it's best if you have another individual present to help you.
The first step is to examine how your sliding glass door is repaired into the track. The majority of sliding glass doors have a strip which runs along the surface of the frame that holds the doorways in vertical alignment, positioning the wheels to fit neatly within the sliding track. To start, let's use a very simple screwdriver to remove that strip at the very top. When the strip is removed, slowly tilt the door out of the frame, then eliminate it out of the frame altogether. Turn the doorway on its side and also examine the wheels at the base of the door. Remember, some sliding glass doors could be upwards of 90 pounds, so either get some help or become very confident on your physical ability.
When the door is on its side, it's possible to carefully inspect the wheels and the track. Most commonly, you will discover the wheels are filled with soot and debris, and the track is also probably very dirty. To clean the brakes, then use compressed air and needle tip pliers. Take care to pull every last hair out of the wheel bearings. It is wise to be diligent in this measure, so you don't have to make a custom of the process. When the wheels are completely clean, spray a tiny bit of penetrating oil into the wheel bearings, spinning the wheel as you use the oil. (The ideal choice for the oil is DuPont's Teflon non-stick dry film lubricant.) It is just as important to clean out the track that the brakes rest on.
Use moist paper towels to remove the grit and soil, and then spray the penetrating oil along the trail so it's well-applied. Use a clean paper towel to make sure it's evenly applied. While you're at it, clean up all the "mating-edges" of the doorway. This is the point where the sliding door meets with another surface of the door frame. A general rule of thumb is to just wipe down anything which seems dirty. Remember, even if the dirt is not always on the trail itself, it may finally fall into the trail causing your doorway to need down another wipe. If you notice any mating edges that feel tacky, have a paper towel and then spray some oil onto it, then wipe out the oil onto the tacky surfaces. After you've done all this, reinstall the doorway. You should notice immediately that the doorway is much easier to slip, and should require significantly less effort.
When for any reason the door remains tough to roll, it's likely one of the following reasons: either your brakes are burnt out, or your sliding glass door is sitting too high on the trail and is consequently hitting the upper plate of the door frame. |} If your brakes are burned out, unfortunately, you are going to have to call the production of your sliding glass door and ask new wheels. If on the other hand, your doorway is hitting the upper plate of your door frame, you can correct it by locating the screw holes at the very base of your sliding glass door. Turn to the right to lift the doorway, or turn to the left to lower the door.