Andersen Sliding Glass Door Screen - If it comes to maintaining your house in tiptop shape, nothing could be more annoying than a sliding glass door which will not slip. After all, what's the purpose of owning a gorgeous glass door which leads into a scenic backyard if the damn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass door angst, I decided to write this report to notify you of the number 1 reason why your sliding glass door will not slip - and everything you can do about it! The number 1 reason why your sliding glass door will not side is that a lot of dirt and debris have clogged up the wheels and the track of your door panel. This is not a difficult fix, but since most sliding glass doors are quite heavy, it's wise if you've got another individual present to aid you.
Step one is to examine how your sliding glass door is repaired into the monitor. The majority of sliding glass doors have a strip which runs across the top of the frame that holds the doorways in vertical orientation, positioning the wheels to fit neatly over the sliding path. To begin, let us use a simple screwdriver to remove that strip at the very top. Once the strip is removed, gradually tilt the door from this frame, then eliminate it from the frame altogether. Turn the door on its side and also examine the wheels in the base of the door. Remember, some sliding glass doors could be upwards of 90 pounds, so either get some aid or be quite confident on your physical ability.
Once the door is on its side, you can carefully examine the wheels and the monitor. Most commonly, you'll discover the wheels are filled with soot and debris, and the track is also likely quite dirty. To clean the brakes, then use compressed air and needle tip pliers. Take care to pull every single hair from the wheel bearings. It's prudent to be diligent in this step, so you don't need to make a custom of this process. Once the wheels are totally clean, spray a tiny bit of peppermint oil to the wheel bearings, spinning the wheel as you apply the oil. (The ideal option for the oil is DuPont's Teflon non invasive dry film lubricant.) It's just as important to clean the track that the wheels rest on.
Use moist paper towels to remove the grit and dirt, and then spray on the penetrating oil across the track so it's well-applied. Use a clean paper towel to make sure it's evenly applied. This is the point where the sliding door matches with any other surface of the door frame. A general guideline is to simply wipe down anything which looks dirty. Remember, even if the dirt is not always on the track itself, it may finally collapse into the track causing your door to require another wipe down. If you become aware of any breeding advantages that feel tacky, have a paper towel and spray some oil on it, then wipe the oil onto the tacky surfaces. When you have done all this, reinstall the door. You should note right away that the door is a lot easier to slip, and should require significantly less effort.
When for any reason that the door is still difficult to roll, it's likely one of these reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the track and is thus hitting on the top plate of the door frame. |} If your wheels are burned out, unfortunately, you'll need to call the manufacture of your sliding glass door and ask new wheels. On most sliding glass doors, there are two screws which could be turned with either a flathead screwdriver or an alan wrench. Switch to the right to lift the door, or switch to the left to lower the door.