Red Glass Door Knob Set - If it comes to maintaining your house in tip-top shape, nothing can be more annoying than a sliding glass door which will not slide. After all, what's the purpose of having a beautiful glass door which leads into a scenic backyard if the damn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass door angst, I chose to write this article to notify you of the number 1 reason why your sliding glass door will not slide - and everything you can do about it! The number 1 reason why your sliding glass door will not side is that too much dirt and debris have clogged the wheels up and the course of your door panel. This is not a hard fix, but since nearly all sliding glass doors are quite heavy, it is best if you have another individual present to help you.
The first step would be to examine how your sliding glass door is fixed into the track. The majority of sliding glass doors have a strip which runs along the surface of the framework that holds the doors in vertical alignment, placing the wheels to fit neatly within the sliding path. To start, let us use a simple screwdriver to remove that strip at the very top. When the strip is removed, slowly tilt the door out of the frame, then remove it out of the frame altogether. Turn the door on its side and also examine the wheels at the bottom of the door. Remember, some sliding glass doors can be upwards of 90 lbs, so either get some help or become very confident in your physical skill.
When the door is on its side, you can closely examine the wheels and the track. Most commonly, you will find the wheels are full of soot and debris, and the track is also likely very dirty. To wash the wheels, use compressed air and needle tip pliers. Be careful to pull every single hair out of the wheel bearings. It is wise to be diligent in this step, so you don't have to make a habit of this procedure. When the wheels are totally sterile, spray a little bit of penetrating oil to the wheel bearings, turning the wheel as you use the oil. (The ideal option for your oil is DuPont's Teflon non invasive dry film lubricant.) It is just as important to clean out the track that the wheels rest on.
Use damp paper towels to remove the grit and soil, and then spray the penetrating oil along the track so it is well-applied. Use a clean paper towel to make sure it is evenly applied. This is where the sliding door meets with another surface of the door frame. A general guideline is to just wipe down anything which looks dirty. Remember, even if the dirt is not always on the track itself, it may eventually collapse into the track causing your door to require down another wipe. If you become aware of any breeding advantages that feel tacky, take a paper towel and then spray some oil onto it, then wipe out the oil onto the tacky surfaces. After you've done all this, reinstall the door. You should notice right away that the door is much simpler to slide, and should require significantly less effort.
If for any reason that the door is still tough to roll, it is probable one of these reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the track and is thus hitting the upper plate of the door frame. |} If your wheels are burnt out, unfortunately, you'll have to call the manufacture of your sliding glass door and request new wheels. On most sliding glass doors, you can find two screws that can be turned using either a flathead screwdriver or an alan wrench. Turn to the right to raise the door, or switch to the left to lessen the door.