Security Screens For Sliding Glass Doors - If it comes to keeping your home in tiptop shape, nothing could be more annoying than a sliding glass door that will not slip. After all, what is the purpose of having a gorgeous glass door that leads into a scenic backyard if the damn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I decided to write this article to notify you of the number 1 reason why your sliding glass door will not slip - and everything you can do about it! The number 1 reason why your sliding glass door will not side is that too much debris and dirt have clogged up the wheels and the course of your door panel. This is not a difficult fix, but because nearly all sliding glass doors are rather heavy, it is best if you've got another individual present to help you.
The first step is to examine how your sliding glass door is fixed into the track. The vast majority of sliding glass doors have a strip that runs across the top of the frame that holds the doors in vertical alignment, positioning the wheels to fit neatly within the sliding path. To begin, let us use a very simple screwdriver to remove that strip on top. When the strip is removed, gradually tilt the door from this frame, then remove it from the frame completely. Turn the doorway on its side and also examine the wheels in the bottom of the door. Remember, some sliding glass doors could be upwards of 90 lbs, so either get some help or become very confident in your physical ability.
Most commonly, you'll find the wheels are filled with soot and debris, and the track is also likely very dirty. To clean the brakes, then use compressed air and needle tip pliers. Be careful to pull every single hair from the wheel bearings. It's wise to be diligent in this measure, so you don't need to make a custom of this process. When the wheels are completely sterile, spray a tiny bit of peppermint oil into the wheel bearings, spinning the wheel as you apply the oil. (The best option for your oil is DuPont's Teflon non invasive dry film lubricant.) It's equally important to clean out the track that the wheels rest on.
Use damp paper towels to remove the grit and dirt, and then spray the penetrating oil across the trail so it is well-applied. Use a clean paper towel to ensure it is evenly applied. This is where the sliding door matches with any other surface of the door frame. A general rule of thumb is to just wipe down anything that seems dirty. Remember, even if the dirt is not necessarily on the trail itself, it can eventually fall into the trail causing your doorway to require down another wipe. If you notice any mating edges that feel sticky, take a paper towel and then spray some oil on it, then wipe out the oil on the sticky surfaces. After you've done all this, reinstall the doorway. You should notice right away that the doorway is much easier to slip, and should require significantly less effort.
When for any reason the door is still tough to roll, it is likely one of these reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the trail and is thus hitting the top plate of the door frame. |} If your wheels are burned out, sadly, you are going to need to call the production of your sliding glass door and request new wheels. If on the other hand, your doorway is hitting the top plate of your door frame, you can correct it by locating the screw holes in the very bottom of your sliding glass door. On most sliding glass doors, there are two screws which could be turned with either a flathead screwdriver or an alan wrench. Turn to the right to raise the doorway, or turn to the left to lower the door.