Frosted Glass Panel Interior Doors - If it comes to keeping your home in tip-top shape, nothing could be frustrating than a sliding glass door which will not slide. After all, what's the purpose of owning a gorgeous glass door which leads into a scenic backyard if the damn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass doorway angst, I decided to write this article to notify you of the number 1 reason why your sliding glass door will not slide - and what you can do about it! The number 1 reason why your sliding glass door will not drawback is that too much dirt and debris have clogged up the wheels and the course of your door panel. This isn't a difficult fix, but since nearly all sliding glass doors are rather heavy, it is wise if you've got another individual present to aid you.
The first step is to analyze how your sliding glass door is repaired into the monitor. The vast majority of sliding glass doors have a strip which runs across the surface of the framework that holds the doors in vertical alignment, placing the wheels to fit neatly within the sliding track. To begin, let's use a simple screwdriver to remove that strip at the very top. Once the strip is removed, gradually tilt the door out of this frame, then eliminate it out of the frame altogether. Turn the doorway on its side and analyze the wheels in the base of the door. Bear in mind, some sliding glass doors could be upwards of 90 pounds, so either acquire some aid or be very confident in your physical ability.
Most commonly, you'll find the wheels are filled with soot and debris, and the track can also be likely very dirty. To clean the brakes, then use compressed air and needle tip pliers. Take care to pull every last hair out of the wheel bearings. It is prudent to be diligent in this measure, so you don't need to make a habit of the procedure. Once the wheels are totally sterile, spray a tiny bit of penetrating oil into the wheel bearings, spinning the wheel as you apply the oil. (The ideal option for the petroleum is DuPont's Teflon non invasive dry film lubricant.) It is just as important to clean out the track that the brakes rest on.
Use moist paper towels to remove the grit and soil, and then spray the penetrating oil across the track so it is well-applied. While you're at it, clean up all of the "mating-edges" of this doorway. This is the point where the sliding door matches with another surface of the door frame. A general guideline is to simply wipe down anything which seems dirty. Bear in mind, even if the dirt isn't necessarily on the track itself, it may eventually collapse into the track causing your doorway to need another wipe down. If you become aware of any mating edges that feel sticky, take a paper towel and then spray some oil onto it, then wipe out the oil on the sticky surfaces. After you have done all this, reinstall the doorway. You should note right away that the doorway is much simpler to slide, and should require significantly less effort.
When for any reason the door remains difficult to roll, it is likely one of the following reasons: either your brakes are burnt out, or your sliding glass door is sitting too high on the track and is thus hitting the top plate of the door frame. |} If your brakes are burnt out, sadly, you'll need to call the production of your sliding glass door and ask new wheels. If on the other hand, your doorway is hitting the top plate of your door frame, you can adjust it by finding the screw holes in the very base of your sliding glass door. On most sliding glass doors, you can find two screws which could be turned with either a flathead screwdriver or an alan wrench. Turn to the right to raise the doorway, or switch to the left to lower the door.