Creative Ways To Cover A Sliding Glass Door - If it comes to maintaining your home in tiptop shape, nothing could be frustrating than a sliding glass door that will not slide. After all, what's the purpose of owning a beautiful glass door that leads out to a scenic backyard if the darn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass doorway angst, I chose to write this article to notify you of the number 1 reason why your sliding glass door will not slide - and everything you can do about it! The number 1 reason why your sliding glass door will not drawback is that a lot of dirt and debris have clogged the wheels up and the track of your door panel. This isn't a difficult fix, but since nearly all sliding glass doors are rather heavy, it's best if you've got another person present to aid you.
Step one would be to examine how your sliding glass door is fixed to the monitor. The majority of sliding glass doors have a strip that runs along the top of the framework that holds the doorways in vertical orientation, positioning the wheels to fit neatly over the sliding path. To begin, let's use a very simple screwdriver to remove that strip on very top. When the strip is removed, slowly tilt the door out of the frame, then eliminate it out of the frame altogether. Turn the doorway on its side and also examine the wheels in the base of the door. Remember, some sliding glass doors could be upwards of 90 lbs, so either acquire some aid or be very confident on your physical ability.
Most commonly, you will discover the wheels are filled with soot and debris, and the track can also be likely very filthy. To wash the wheels, use compressed air and needle tip pliers. Be careful to pull every last hair out of the wheel bearings. It's prudent to be diligent at this step, so you don't have to make a habit of the process. When the wheels are completely clean, spray a little bit of penetrating oil to the wheel bearings, turning the wheel as you apply the oil. (The ideal choice for the petroleum is DuPont's Teflon non invasive dry film lubricant.) It's equally important to clean out the track that the brakes rest on.
Use moist paper towels to remove the grit and dirt, and then spray on the penetrating oil along the trail so it's well-applied. While you're at it, clean up all of the "mating-edges" of the doorway. This is the point where the sliding door matches with another surface of the door frame. A general rule of thumb is to just wipe down anything that looks filthy. Remember, even when dirt isn't necessarily on the trail itself, it may eventually fall to the trail causing your doorway to need down another wipe. If you become aware of any mating edges that feel tacky, have a paper towel and spray some oil on it, then wipe out the oil on the tacky surfaces. After you've done all this, reinstall the doorway. You should note right away that the doorway is much easier to slide, and should require significantly less effort.
When for any reason the door is still tough to rollup, it's likely one of the following reasons: either your brakes are burnt out, or your sliding glass door is sitting too high on the trail and is thus hitting on the top plate of the door frame. |} If your brakes are burnt out, sadly, you'll have to call the manufacture of your sliding glass door and ask new wheels. On most sliding glass doors, there are two screws which could be turned using either a flathead screwdriver or an alan wrench. Switch to the right to lift the doorway, or switch to the left to lessen the door.