Leaded Glass Cabinet Door Panels - When it comes to maintaining your home in tiptop shape, nothing can be more annoying than a sliding glass door which will not slide. After all, what is the purpose of owning a gorgeous glass door which leads out to a scenic backyard if the damn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass door angst, I chose to write this report to inform you of the number 1 reason why your sliding glass door will not slide - and everything you can do about it! The number 1 reason why your sliding glass door will not drawback is that a lot of dirt and debris have clogged the wheels up and the course of your door panel. This isn't a hard fix, but since nearly all sliding glass doors are quite heavy, it is best if you've got another person present to help you.
The first step is to analyze how your sliding glass door is repaired to the monitor. The vast majority of sliding glass doors have a strip which runs along the surface of the frame that holds the doorways in vertical orientation, positioning the wheels to fit neatly within the sliding track. To begin, let's use a simple screwdriver to remove that strip at the very top. Once the strip is removed, gradually tilt the door out of the frame, then eliminate it out of the frame altogether. Turn the door on its side and analyze the wheels in the bottom of the door. Remember, some sliding glass doors can be upwards of 90 lbs, so either get some help or become quite confident in your physical ability.
Most commonly, you will find the wheels are filled with soot and debris, and the track is also probably quite filthy. To wash the brakes, then use compressed air and needle tip pliers. Be careful to pull every single hair out of the wheel bearings. It's wise to be diligent at this measure, so you don't have to make a habit of this procedure. Once the wheels are completely clean, spray a little bit of penetrating oil to the wheel bearings, spinning the wheel as you use the oil. (The best option for your petroleum is DuPont's Teflon non-stick dry film lubricant.) It's just as important to clean the track that the wheels rest on.
Use damp paper towels to remove the grit and dirt, and then spray the penetrating oil along the track so it is well-applied. This is the point where the sliding door matches with another surface of the door frame. A general rule of thumb is to simply wipe down anything which looks filthy. Remember, even if the dirt isn't necessarily on the track itself, it can finally fall to the track causing your door to need down another wipe. If you become aware of any breeding advantages that feel tacky, take a paper towel and spray some oil onto it, then wipe the oil onto the tacky surfaces. After you have done all this, reinstall the door. You should note right away that the door is much simpler to slide, and should require significantly less effort.
When for any reason the door remains difficult to roll, it is likely one of these reasons: either your wheels are burnt out, or your sliding glass door is sitting too high on the track and is thus hitting the top plate of the door frame. |} If your wheels are burnt out, sadly, you'll have to call the manufacture of your sliding glass door and request new wheels. If on the other hand, your door is hitting the top plate of your door frame, you can correct it by locating the screw holes in the very bottom of your sliding glass door. Switch to the right to lift the door, or switch to the left to lower the door.