Etched Glass Shower Door Designs - If it comes to keeping your house in tiptop shape, nothing can be more annoying than a sliding glass door which will not slip. After all, what's the purpose of having a beautiful glass door which leads into a scenic backyard if the darn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass doorway angst, I decided to write this report to notify you of the number 1 reason why your sliding glass door will not slip - and what you can do about it! The number 1 reason why your sliding glass door will not drawback is that too much debris and dirt have clogged up the wheels and the track of your door panel. This isn't a hard fix, but because nearly all sliding glass doors are rather heavy, it's wise if you have another person present to help you.
Step one is to examine how your sliding glass door is fixed into the monitor. The vast majority of sliding glass doors have a strip which runs along the top of the frame that holds the doors in vertical orientation, placing the wheels to fit neatly over the sliding track. To begin, let us use a very simple screwdriver to remove that strip at the top. When the strip is removed, gradually tilt the door out of the frame, then eliminate it out of the frame altogether. Turn the doorway on its side and also examine the wheels at the bottom of the door. Bear in mind, some sliding glass doors can be upwards of 90 lbs, so either get some help or be quite confident in your physical ability.
Most commonly, you will discover the wheels are filled with soot and debris, and the track can also be probably quite dirty. To wash the brakes, then use compressed air and needle tip pliers. Take care to pull every single hair out of the wheel bearings. It's wise to be diligent at this step, so you don't need to make a habit of this procedure. When the wheels are totally sterile, spray a little bit of penetrating oil into the wheel bearings, turning the wheel as you apply the oil. (The ideal option for your petroleum is DuPont's Teflon non-stick dry film lubricant.) It's just as important to clean the track that the brakes rest on.
Use damp paper towels to remove the grit and soil, and then spray on the penetrating oil along the track so it's well-applied. This is the point where the sliding door matches with another surface of the door frame. A general guideline is to simply wipe down anything which seems dirty. Bear in mind, even when dirt isn't always on the track itself, it may eventually fall into the track causing your doorway to need down another wipe. If you notice any mating edges that feel tacky, take a paper towel and spray some oil onto it, then wipe the oil onto the tacky surfaces. When you have done all this, reinstall the doorway. You should notice right away that the doorway is a lot easier to slip, and should require significantly less effort.
When for any reason the door remains tough to roll, it's likely one of the following reasons: either your brakes are burnt out, or your sliding glass door is sitting too high on the track and is thus hitting on the top plate of the door frame. |} If your brakes are burnt out, sadly, you'll need to call the manufacture of your sliding glass door and request new wheels. Turn to the right to raise the doorway, or switch to the left to lessen the door.