Folding Glass Patio Doors With Screens - If it comes to keeping your home in tiptop shape, nothing could be frustrating than a sliding glass door which won't slip. After all, what's the purpose of having a gorgeous glass door which leads out to a picturesque backyard if the damn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass door angst, I decided to write this article to notify you of the number 1 reason why your sliding glass door won't slip - and what you can do about it! The number 1 reason why your sliding glass door won't side is that a lot of debris and dirt have clogged up the wheels and the course of your door panel. This isn't a difficult fix, but because nearly all sliding glass doors are quite heavy, it is wise if you've got another individual present to aid you.
The first step is to examine how your sliding glass door is repaired into the monitor. The vast majority of sliding glass doors have a strip which runs along the surface of the frame that holds the doors in vertical alignment, placing the wheels to fit neatly over the sliding track. To begin, let us use a very simple screwdriver to remove that strip at the very top. Once the strip is removed, gradually tilt the door out of the frame, then remove it out of the frame completely. Turn the door on its side and examine the wheels at the bottom of the door. Remember, some sliding glass doors could be upwards of 90 lbs, so either get some aid or become quite confident in your physical skill.
Once the door is on its side, it's possible to closely examine the wheels and the monitor. Most commonly, you'll find the wheels are filled with soot and debris, and the track is also probably quite dirty. To clean the wheels, use compressed air and needle tip pliers. Take care to pull every last hair out of the wheel bearings. It is wise to be diligent at this step, so you don't have to make a habit of the procedure. Once the wheels are completely clean, spray a tiny bit of penetrating oil to the wheel bearings, turning the wheel as you use the oil. (The best choice for your oil is DuPont's Teflon non-stick dry film lubricant.) It is equally important to clean the track that the wheels rest on.
Use moist paper towels to remove the grit and dirt, and then spray the penetrating oil along the trail so it is well-applied. While you're at it, clean up all of the "mating-edges" of the door. This is the point where the sliding door matches with another surface of the door frame. A general rule of thumb is to simply wipe down anything which looks dirty. Remember, even if the dirt isn't always on the trail itself, it may eventually collapse into the trail causing your door to need another wipe down. If you notice any breeding advantages that feel sticky, have a paper towel and spray some oil onto it, then wipe the oil on the sticky surfaces. After you have done all this, reinstall the door. You should notice right away that the door is much simpler to slip, and should require significantly less effort.
If for any reason that the door is still tough to rollup, it is probable one of the following reasons: either your wheels are burnt out, or your sliding glass door is sitting too high on the trail and is thus hitting the upper plate of the door frame. |} If your wheels are burned out, unfortunately, you are going to have to call the production of your sliding glass door and ask new wheels. Switch to the right to raise the door, or turn to the left to lower the door.