Frameless Glass Door On Tub - When it comes to maintaining your home in tip-top shape, nothing could be frustrating than a sliding glass door which won't slip. After all, what's the purpose of having a beautiful glass door which leads out to a picturesque backyard if the damn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass door angst, I chose to write this report to notify you of the number 1 reason why your sliding glass door won't slip - and everything you can do about it! The number 1 reason why your sliding glass door won't drawback is that a lot of dirt and debris have clogged up the wheels and the course of your door panel. This isn't a hard fix, but because nearly all sliding glass doors are rather heavy, it is best if you've got another person present to aid you.
The first step would be to examine how your sliding glass door is repaired to the monitor. The vast majority of sliding glass doors have a strip which runs across the surface of the frame that holds the doors in vertical alignment, positioning the wheels to fit neatly within the sliding track. To start, let us use a very simple screwdriver to remove that strip at the top. When the strip is removed, gradually tilt the door out of the frame, then remove it out of the frame altogether. Turn the door on its side and examine the wheels in the base of the door. Remember, some sliding glass doors could be upwards of 90 pounds, so either acquire some aid or become very confident on your physical ability.
When the door is on its side, you can carefully examine the wheels and the monitor. Most commonly, you'll find the wheels are full of soot and debris, and the track can also be likely very filthy. To wash the wheels, use compressed air and needle tip pliers. Be careful to pull every single hair out of the wheel bearings. It is wise to be diligent at this measure, so you don't have to make a habit of the procedure. When the wheels are totally sterile, spray a little bit of peppermint oil to the wheel bearings, spinning the wheel as you apply the oil. (The best option for the oil is DuPont's Teflon non invasive dry film lubricant.) It is equally important to clean out the track that the wheels rest on.
Use moist paper towels to remove the grit and soil, and then spray on the penetrating oil across the track so it is well-applied. While you're at it, clean up all of the "mating-edges" of the door. This is where the sliding door matches with another surface of the door frame. A general guideline is to simply wipe down anything which seems filthy. Remember, even when dirt isn't necessarily on the track itself, it can eventually fall to the track causing your door to require another wipe down. If you become aware of any mating edges that feel sticky, take a paper towel and spray some oil onto it, then wipe out the oil on the sticky surfaces. When you've done all this, reinstall the door. You should note right away that the door is much easier to slip, and should require significantly less effort.
If for any reason the door is still tough to roll, it is likely one of these reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the track and is thus hitting on the top plate of the door frame. |} If your wheels are burnt out, unfortunately, you are going to have to call the manufacture of your sliding glass door and request new wheels. Turn to the right to lift the door, or switch to the left to lessen the door.