Standard Size Of Sliding Glass Door Curtains - When it comes to maintaining your house in tiptop shape, nothing could be more annoying than a sliding glass door which won't slip. After all, what is the purpose of having a gorgeous glass door which leads out to a picturesque backyard if the darn thing takes three NFL linebackers to slip it open? So having personally experienced such sliding glass door angst, I chose to write this report to notify you of the number 1 reason why your sliding glass door won't slip - and everything you can do about it! The number 1 reason why your sliding glass door won't drawback is that too much dirt and debris have clogged up the wheels and the course of your door panel. This isn't a difficult fix, but since nearly all sliding glass doors are rather heavy, it is best if you've got another person present to help you.
Step one is to analyze how your sliding glass door is fixed to the monitor. The vast majority of sliding glass doors have a strip which runs along the top of the frame that holds the doors in vertical orientation, placing the wheels to fit neatly over the sliding track. To begin, let's use a very simple screwdriver to remove that strip at the top. Once the strip is removed, slowly tilt the door from the frame, then remove it from the frame completely. Turn the door on its side and analyze the wheels in the base of the door. Bear in mind, some sliding glass doors could be upwards of 90 lbs, so either get some help or become quite confident on your physical ability.
Most commonly, you'll discover the wheels are full of soot and debris, and the track can also be likely quite filthy. To wash the wheels, use compressed air and needle tip pliers. Be careful to pull every last hair from the wheel bearings. It is prudent to be diligent at this step, so you don't have to make a custom of this procedure. Once the wheels are completely sterile, spray a little bit of penetrating oil into the wheel bearings, spinning the wheel as you use the oil. (The best choice for your oil is DuPont's Teflon non invasive dry film lubricant.) It is equally important to clean out the track that the wheels rest on.
Use moist paper towels to remove the grit and dirt, and then spray the penetrating oil along the trail so it is well-applied. Use a clean paper towel to ensure it is evenly applied. This is the point where the sliding door matches with any other surface of the door frame. A general rule of thumb is to simply wipe down anything which seems filthy. Bear in mind, even if the dirt isn't always on the trail itself, it can eventually fall to the trail causing your door to need down another wipe. If you notice any mating edges that feel tacky, have a paper towel and then spray some oil on it, then wipe out the oil onto the tacky surfaces. After you have done all this, reinstall the door. You should notice right away that the door is much simpler to slip, and should require significantly less effort.
When for any reason the door is still tough to rollup, it is probable one of these reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the trail and is thus hitting the upper plate of the door frame. |} If your wheels are burnt out, unfortunately, you are going to have to call the manufacture of your sliding glass door and request new wheels. If on the other hand, your door is hitting the upper plate of your door frame, you can correct it by locating the screw holes in the very base of your sliding glass door. On most sliding glass doors, there are two screws that could be turned using either a flathead screwdriver or an alan wrench. Switch to the right to lift the door, or turn to the left to lessen the door.