Single Panel Sliding Glass Door - If it comes to maintaining your home in tip-top shape, nothing could be more annoying than a sliding glass door which won't slide. After all, what is the purpose of having a gorgeous glass door which leads into a picturesque backyard if the darn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass door angst, I chose to write this article to inform you of the number 1 reason why your sliding glass door won't slide - and what you can do about it! The number 1 reason why your sliding glass door won't side is that too much dirt and debris have clogged up the wheels and the track of your door panel. This isn't a difficult fix, but since nearly all sliding glass doors are quite heavy, it is wise if you've got another individual present to help you.
Step one is to analyze how your sliding glass door is repaired to the monitor. The majority of sliding glass doors have a strip which runs along the top of the framework that holds the doorways in vertical orientation, positioning the wheels to fit neatly over the sliding path. To start, let's use a simple screwdriver to remove that strip on top. Once the strip is removed, gradually tilt the door from the frame, then eliminate it from the frame altogether. Turn the door on its side and analyze the wheels at the bottom of the door. Remember, some sliding glass doors could be upwards of 90 pounds, so either get some help or become quite confident on your physical skill.
Most commonly, you will discover the wheels are full of soot and debris, and the track is also probably quite filthy. To clean the brakes, then use compressed air and needle tip pliers. Take care to pull every last hair from the wheel bearings. It's wise to be diligent at this measure, so you don't need to make a custom of the procedure. Once the wheels are totally clean, spray a little bit of penetrating oil into the wheel bearings, turning the wheel as you apply the oil. (The best option for the oil is DuPont's Teflon non invasive dry film lubricant.) It's equally important to clean out the track that the wheels rest on.
Use damp paper towels to remove the grit and dirt, and then spray the penetrating oil along the track so it is well-applied. While you're at it, clean up all the "mating-edges" of the door. This is the point where the sliding door meets with any other surface of the door frame. A general guideline is to simply wipe down anything which seems filthy. Remember, even when dirt isn't always on the track itself, it may finally fall to the track causing your door to need down another wipe. If you notice any breeding advantages that feel tacky, take a paper towel and spray some oil on it, then wipe out the oil on the tacky surfaces. After you've done all this, reinstall the door. You should notice immediately that the door is much simpler to slide, and should require significantly less effort.
When for any reason the door is still tough to rollup, it is likely one of the following reasons: either your wheels are burnt out, or your sliding glass door is sitting too high on the track and is consequently hitting the top plate of the door frame. |} If your wheels are burnt out, unfortunately, you'll need to call the manufacture of your sliding glass door and request new wheels. On most sliding glass doors, there are two screws which could be turned using either a flathead screwdriver or an alan wrench. Switch to the right to lift the door, or switch to the left to lessen the door.